Syzygy SLF800, Руководство по эксплуатации

Страница: 14 / 18

10
SYZYGY | Operating Instructions
SOPHISTICATED OVERLOAD PROTECTION
Your new Syzygy subwoofer boasts a sophisticated electronic stabilization and overload protection system designed
to constantly monitor fluctuations in temperature, voltage and current. All of this happens in the background, without
you noticing a thing and with absolutely no effect on your Syzygy subwoofer’s ability to play loud …
During even the most demanding passages of bass reproduction, moments when your Syzygy sub and speakers are
working together at full capacity, bass reproduction remains clean, clear and virtually free of audible distortion.
TROUBLESHOOTING
WHAT’S THE TROUBLE?
No signal
Output level is too low
More subwoofer output required
Loud hum
Sporadic low hum
Sound distortion or buzzing,
particularly noticeable when
system is playing loud
POSSIBLE CAUSE
Faulty fuse
No mains connection
No input signal
Source output level is set too low
Tighten up room placement of
subwoofer (See “Subwoofer
Placement” on page 2.)
Faulty connection or contact
Faulty connection or contact
Faulty connectio or contact
Centre speaker or surround
speakers are being overdriven
WHAT TO DO
Check fuse and replace if required
Check Mains switch, plug(s) and
socket(s)
Check all input connections.
Confirm RCA cables are properly
inserted and working correctly.
It could be the signal source: listen
to see if another audio component
in the system is playing.
Increase output level of preamp
and reduce output level of
power amp.
Reduce gain on system speakers
and increase master volume level.
Place your subwoofer closer to a
wall or in a corner.
IMPORTANT! When you move the
subwoofer’s position in the room
you must use the Syzygy Sub
Control App to Auto EQ again.
Recheck all connections.
Recheck all connections.
Adjust the output level of centre
speaker and surround speakers at
the preamplifier. Use center mode
‘Normal’