Sytech SY-1709, Руководство пользователя

Страница: 6 / 12

Select a file
There are three memory storage areas (file folder) labeled A,B,C in the
unit for your choice, it can store 999 files in each file folder, so it can store
2997 in all. Absolutely, it must be subject to its memory capacity.
1. At voice mode, press the File/A-B key to switch file folder.
* The Factory setting is “A”
2. As shown on the right picture, it shows the file folder and other
detailed information of this recording file on the LCD.
NOTE: If the memory is full, “FULL” will appear on the LCD, so delete or
remove files, or replace a new Micro SD card as storage.
Preparing for recording
Before recording, you can set the VOR function. If it is turned on and the
detected volume doesn’t reach the VOR level value (set by system), the
recording will pause until it detects eligible volume, otherwise it will
continue recording a soundless section in this file.
1. At voice mode, you may select a desired file by using the file/A-B
key. You may set VOR function in advance.
2. The first several minutes sound may not be recorded, it’s just for
activating the recorder.
OPERATION
Recording files
1. After finishing preparing the operation, just push the Record key up
to start a recording, the elapsed recording time and the other
status will be shown on the LCD.
2. When it doesn’t detect voice, the elapsed recording time will pause,
and the upper “VOR” will blink until it can detect voice again.
1. If you need a pause, just press PLAY/PAUSE key, and the elapsed
recording time pauses and blinks, then press it again to continue
recording. At last, push the Record key down to stop and save this
recording.
NOTE
** There are two ways for recording input (Internal Mic, External Mic).
** It is recommended to place the unit 50mm from the sound source.