PAGE
3.2 S4.3 Controller Basic
Set-up
3.21 Placement
The S4.3 Controller is designed to
complement high quality home
entertainment components cosmetically.
Place it on a stable surface
in an equipment rack or
cabinet. Note that the S4.3
Controller is slightly deeper than most
sources (tuners, CD players, cassette
decks, etc.) and should not generally
be placed on top of these units.
The exact location may be governed
by existing wiring such as
Satellite or TV points, or
be determined by the
location of the existing
Hi-Fi system in which
case the central location point will
probably be in the lounge or family room.
Alternatively, if the Multi-room System is
to operate separately from (or instead of)
the main Hi-Fi system, the central location
point could be anywhere - hidden in a
cabinet in the hall or even under the
staircase - the only access required is to
change discs or tapes. See also Section 3.4
(Recommended A/V Wiring).
IMPORTANT
The S4.3 Controller contains 4
stereo power amplifiers which can
generate significant amounts of
heat. It is therefore necessary to
ensure that the controller is located
in an area where there is adequate
ventilation. Under no circumstances
should the ventilation slots at the
top and rear of the unit be
obstructed. If the S4.3 Controller is
mounted in a cabinet, ensure that
cool air can circulate when the doors
are closed. Ventilation slots/holes
should be provided at the top and
bottom of the cabinet.
Section 3 • System Planning
Minimum internal depth 500 mm
Tuner
C.D.
Tape
Optional Main
Amplifier
Super Controller
Minimum internal
width 450 mm
Doors
Infra-Red
Beam
Cut-away of equipment cabinet
The S4.3 Controller can also be mounted
on an open shelf - see Section 3.23.
3.22 Connections:
Make sure that you have enough room to
run all the connecting cables and dress
them appropriately behind the S4.3
Controller. Although each connection is
fully explained in the following sections
of this manual, take a quick glance
through the following list of possibilities
and decide how much space you will
need. Also remember that these cables
will make the S4.3 Controller much more
difficult to move when they are
connected. Plan accordingly.
a) Four pairs of PHONO to PHONO
interconnects – one from each source.
b) Four more pairs of PHONO to PHONO
interconnect cables – one each to the
appropriate input of the main system’s
preamplifier, etc., from the corresponding
“loop through” output on the S4.3
Controller (These will not be needed if
the S4.3 Controller is used as a stand-
alone controller).
7
Содержание S4.3
Страница 1: ...MULTI ROOM SYSTEM S4 3 S4 3 MULTI ROOM SYSTEM I n s t a l l a t i o n M a n u a l...
Страница 43: ...PAGE 40...