SystemAir VR 300 ECV/B, Описание установки

Страница: 8 / 75

_________________________________________________________________________________________________________
VR 300 ECV/B
Installation description
206552 (12-12-2012)
8
Systemair AB
Transport and storage
VR 300 ECV/B is delivered in one piece on a pallet for easy transportation using a forklift. The unit should
be stored and transported in such a way that it is protected against physical damage that can harm
panels, handles, display etc. It should be covered so that dust, rain and snow cannot enter and damage
the unit and its components. The appliance is delivered complete with all necessary components, wrapped
in plastic on a pallet for easy transportation.
Where/how to install
1) First chose installation position for the unit, considering that duct runs should be as simple as
possible.
2) If necessary the inspection hatches must be exchanged so that the hatch equipped with fixing clips for
front door panel (pos.10, fig.3 ) becomes the unit front. The hatch with fixing clips has improved noise
insulation, and this operation is therefore required even if front door panel is not to be mounted.
3) Install the mounting bracket (pos.4, fig.3 ) on top of the unit by means of provided screws and fix self-
adhesive anti vibration seal (pos.3, fig.3) on the lower part of the unit’s back side.
4) Install the wall bracket (pos.1, fig.3 ) with anti vibration pad. Bottom side of bracket should be 40mm
below top of unit position, alternatively 590mm from the bottom position. Check that the anti vibration
seal (pos.2,
fig.3 ) is undamaged.
5) Lift the unit into position and make sure that there is no direct contact between unit and building
construction.
The unit should preferably be installed in a separate room (e.g. storeroom, laundry room or similar). Duct
from cooker hood can be connected to bypass duct (pos.7
fig.3 ) in top or bottom of the unit. As an
alternative, a cooker hood can be connected directly under the unit. The unit is designed for installation on
the wall, but can also be installed horizontally, i.e. hanging (separate instructions enclosed with brackets
for hanging installation) or lying. If installed lying, remember to mount necessary anti vibration pads under
the unit. The unit is equipped with large inspection hatches on both sides, and is laterally reversible for
flexible and simple connection to duct system.
When choosing the installation position, consideration must be taken that the unit requires regular
maintenance. Make sure that the inspection doors are available for maintenance/service. Leave free
space for removing of inspection doors and main components inside the unit. If the unit is installed on a
light wall construction towards a living room (e.g. bedroom), we recommend that the wall is insulated/
designed so that transfer of noise is avoided.
Recommended installation location for the outdoor air intake is the northern or eastern side of the building
and with a distance to openings for discharge of stale ventilation air, kitchen ventilator, central vacuum
system, waist water drainage and other pollution sources like exhaust from traffic etc. Stale discharge air
should ideally be led via a roof unit to outside and with a good distance to any outdoor air intake, windows
etc.
When the unit is installed over the cooker, a kitchen cupboard door (pos.11, fig.3 ) can be mounted to
cover the unit front, by means of the provided clip-in receptacle and stud (re. installation instructions on
mounting template).
White painted or Stainless, insulated front cover (alternative to kitchen cupboard door) (pos.12,
fig.3 ),
white side panels (where unit side is visible) (pos.14, fig.3 ) and white painted duct cover (pos.13, fig.3 )
between ceiling and unit (H=295mm) can be supplied as additional equipment.