SystemAir Topvex TR 09 EL, Инструкция по установке

Страница: 10 / 26

____________________________________________________________________________________________________
Topvex TR09, TR11 & TR15
Installation instruction
205007 Systemair AB
10
Dimension and Weight
Dimension and weight See
fig. 1.
Handle and hinges are removable.
Inspection doors can open without handle by using a 16mm cap key.
Transport and storage
The Topvex should be stored and transported in such a way that it is protected against physical damage
that can harm panels, handles, display etc. It should be covered so that dust, rain and snow cannot enter
and damage the unit and its components. The unit is delivered in one piece containing all necessary
components, wrapped in plastic on a pallet for easy transportation. If separation is required, please refer to
section headed "Separation of the appliance".
The appliance may be lifted using a forklift truck or a pallet loader. To avoid collapse of the unit’s feet, do
not try to slide the unit into place after it has been put down on the ground.
Where/how to Install
The unit is meant for indoor and horizontal installation. The electronic components should not be exposed
to lower temperature than 0°C or higher than +50°C.
When mounting; make sure to leave enough space to access the service doors. It is the heat exchanger
(rotor) that determines the size of the space necessary for service. See
fig 1
for measurement
requirements. General maintenance includes replacing the filters and removing fan motors and exchanger
block inside the unit for cleaning.
Avoid placing the unit against a wall, as low frequency noise can cause vibrations in the wall.
The outdoor air intake of the building should if possible be put in the northern or eastern side of the
building and away from other exhaust outlets like kitchen fan outcasts or laundry room outlets. The extract
air should ideally be led out via a roof cowl away from any outdoor air intakes, windows, balconies etc.
Note!
If the handles are used, the required safety for the unit is only reached if the handles are locked and
the keys kept in a secure place during operation.
The unit must be duct connected or in some other way provided with protection so that it is not possible to
come in contact with the fans through the duct connections.