SystemAir SyScrew Water EVO CO 1070 /S, Руководство по установке и обслуживанию

Страница: 13 / 60

11
E
n
g
li
sh 3 - Transport, Lifting and Positioning
Refrigerators are supplied assembled (apart from standard
antivibrating rubber supports, that will be installed on site). The
equipment are full of refrigerant and oil, in the quantity required for a
proper operation.
3.1 Inspection
When the unit is delivered, it is recommended to check it carefully
and to identify any damage occurred during transportation. The
goods are shipped ex-factory, at the buyer’s risk. Check that the
delivery includes all the components listed in the order.
In case of damage, note it down on the carrier’s delivery note and
issue a claim according to the instructions provided in the delivery
note.
In the presence of any serious damage, that does not affect the
surface only, it is recommended to inform manufacturer immediately.
Please note that manufacturer may not be held liable for any damage
to the equipment during transportation, even though the carrier has
been appointed by the factory.
3.2 Lifting
The unit must be lifted by using the hooks inserted into the relevant
eyebolts (see the figure).
It is recommended to use a spacer to prevent cables from damaging
the unit (see the figure). For sizes equipped with 1 compressor (440-
770) the minimum size of the spacer is 1350 mm. For sizes equipped
with 2 compressors (860-1550) the minimum size of the spacer is
1520 mm.
Before positioning the unit, make sure that the place of installation is
appropriate and sturdy enough to hold the weight and to withstand
the stress caused by the operation of the whole assembly.
WARNING
Do not displace the unit on rollers, and do not
lift it with a lift truck.
Unit must be lifted carefully.
To lift unit slowly and regularly.
To lift and displace the unit:
Q
Insert and secure eyebolts into the holes marked on the frame.
Q
Insert spacer between cables.
Q
Hook near the barycentre of the unit.
Q
The cables must be long enough to form, if tensioned, an angle
of at least 45° with respect to the horizontal plane.