First time start
After all connections have been made installation is completed by switching on the mains
supply.
Make sure the
S111SX Node Manager
software is running and the PC-interface is
connected to the LON
®
network.
Activate the
Service Pin
using a small screw-driver or equivalent, refer to the fold-out page
drawing for exact location of the
Service Pin
.
Please note, that it is of
outmost importance
to keep track of the order in which the
various
System X
units are activated e.g. by carefully noting the exact time the
Service Pin
is
activated. This information is crucial when identification and configuration of each unit is
carried out later using the
S111SX Node Manager
.
Note: Strictly follow the above instructions to avoid possible configuration problems.
The
Service Pin
may be activated later also if reconfiguration of the network is needed,
however, always make sure the S111SX Node Manager software is on-line prior to pressing
the Service Pin.
LED indicators
A green LED is placed at the front and an yellow LED at the rear panel.
Front panel indicator
The green LED indicates the status of the matrix:
Ÿ
Steadily flashing once every second: Normal operation.
Ÿ
Constantly on or off: Fault situation; disconnect from mains supply and
re-connect again.
Ÿ
Flashing erractic: Download of new settings in progress.
Rear panel indicator
The yellow LED indicates the LON
®
network status:
Ÿ
Off indicates normal operation; the unit is configured and running.
Ÿ
Flashing and on indicates that the unit isn’t configured; run the S111SX
Node Manager and press the Service Pin.
Note: The LON
®
LED flashes shortly when the Service Pin is activated - this is not a fault
condition.
Video standard selection
By enabling a two-pole pinheader; i.e. shorting the two terminals with a “jumper”, located
on the main board the NTSC/RS-170 video standard is selected. The M3216AX features two
main PCB’s each having a pinheader. Top PCB is handling video outputs 9-16, bottom PCB
video outputs 1-8.
Factory default setting is PAL/CCIR; i.e. no jumper installed. Installing/removal of the jumper
must be followed by a matrix re-boot.
Refer to the fold-out page drawing for exact location of the pinheader.
2850-00002
Page 7
S Y S E M
