Introduction
The Series
Matrix X
consists of a number of video matrix units controlled via
L
ON
W
ORKS
®
:
Ÿ
M3216AX
: 32 video inputs / 16 video outputs with loop facilities on both video
inputs and outputs for easy expansion.
Ÿ
M3208AX
: 32 video inputs / 8 video outputs with loop facilities on both video inputs
and outputs for easy expansion.
Ÿ
M1608AX
: 16 video inputs / 8 video outputs.
Ÿ
M3216XX:
Used as an cost saving expansion unit in combination with the M3216AX
only. In an expanded system not all matrix units have cameras or monitors
connected. At these location(s) the M3216XX unit is used which consequently is
equipped with video loop connectors only; no BNC- video connectors are available.
By interconnecting several Matrix X units the number of video inputs and/or outputs is
increased.
The video input terminations can be programmed to 75
Ω
or high impedance (Hi-Z).
All settings are selected remotely using the
S111SX Node Manager
- no settings are
possible on the unit itself, except selection of video standard; either PAL/CCIR (factory
default) or NTSC/RS-170.
Daily operation is carried out via the keyboards Series
K111xX
.
Validity
This manual cover the Matrix X types M3216AX, M3216XX, M3208AX and M1608AX,
serial number M
xxxx
xX-0100, where “
xxxx
x” represents the typenumber, or higher.
The described
Remote Site
functionality is available with the
Node Manager V.2.0
or higher.
Compatibility
The Matrix X is compatible with any SYSTEM X component.
Any device outputting a standard 1 V
pp
video signal may be connected to the video inputs.
Approvals
All electronic equipment can emit, or be sensitive to, induced electromagnetic noise, which
can be conducted the connected wires or transmitted as electromagnetic fields.
Electromagnetic noise can cause malfunction or damage to the equipment.
The Matrix X is
-certified and approved in accordance with the EU-directives regarding
Electromagnetic Compatibility, the EMC-directive, and Low Voltage safety, the LVD-directive
with respect to the EN 50081-1 (EMC, emission), the EN 50130-4 (EMC, immunity) and the
EN 60950 (LVD, safety) standards.
WARNING: To fulfil the above regulations make sure to carefully follow
the installation instructions in this manual.
Trademarks
Echelon
®
, LON
®
and
L
ON
W
ORKS
®
are trademarks of Echelon Corporation registered in the
United States of America and other countries.
S Y S E M
Page 2
2850-00002
