System Sensor BEAM1224A, Инструкция по установке и обслуживанию

Страница: 10 / 18

Figure 11. Alignment Adjustment Locations
ALIGNMENT MIRROR
ALIGNMENT GUNSIGHT
DIGITAL SIGNAL
STRENGTH
READOUT
HORIZONTAL
ADJUSTMENT
VERTICAL
ADJUSTMENT
OPTICS
LOCK-DOWN
SCREWS
ALIGNMENT
POSITION
INDICATOR
C0264-00
Figure 12. Coarse Alignment Procedure
EYE
REFLECTOR
C0625-00
Figure 13. Housing Screw Locations
SCREW
LOCATIONS
SCREW
LOCATIONS
RESET
SWITCH
C0266-00
Sensitivity Selection
The detector has six sensitivity selections. Each of these selec-
tions is only acceptable over a specific distance separation
between the detector and the reflector per ULC and UL268. The
chart below is used to determine which selections are acceptable
for your installed distance. The sensitivity of the detector can
be set only when the housing is removed and the detector is not
in the fine adjustment step of the alignment mode, indicated by
the illumination of the dual digital display. To set the sensitiv-
ity depress the sensitivity button one time. See Figure 10. Once
the switch is pressed the digital display will illuminate and read
the current sensitivity setting in percent obscuration. To change
the sensitivity continue to depress the sensitivity switch until
the desired setting is achieved. The digital display will turn off
automatically if no further switch presses occur.
Sensitivity
Setting
%
Obscuration
Display
Reading
Acceptable
Distance
Between
Detector
and
Reflector
(Feet)
Acceptable
Distance
Between
Detector
and
Reflector
(meters)
Level 1 25 25 16.4 to 120 5.0 to 37.2
Level 2 30 30 25 to 150 7.6 to 46.6
Level 3 40 40 60 to 220 18.3 to 67
Level 4 50 50 80 to 328 24.4 to 100
Acclimate
Level 1
30 to 50 A1 80 to 150 24.4 to 45.7
Acclimate
Level 2
40 to 50 A2 80 to 220 24.4 to 67
D400-73-00 10 I56-2541-00R