background image

 SS-450-000 

I56-3387-005R 

 

 

©2012 System Sensor

System Sensor warrants its enclosed smoke detector base to be free from defects in mate-
rials and workmanship under normal use and service for a period of three years from date 
of manufacture. System Sensor makes no other express warranty for this smoke detector 
base. No agent, representative, dealer, or employee of the Company has the authority to 
increase or alter the obligations or limitations of this Warranty. The Company’s obligation 
of this Warranty shall be limited to the repair or replacement of any part of the smoke 
detector base which is found to be defective in materials or workmanship under normal 
use and service during the three year period commencing with the date of manufacture. 
After phoning System Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return 
Authorization number, send defective units postage prepaid to: System Sensor, Returns 

Three-Year LimiTed WarranTY

Department, RA #__________, 3825 Ohio Avenue, St. Charles, IL 60174. Please include a 
note describing the malfunction and suspected cause of failure. The Company shall not 
be obligated to repair or replace units which are found to be defective because of damage, 
unreasonable use, modifications, or alterations occurring after the date of manufacture. 
In no case shall the Company be liable for any consequential or incidental damages for 
breach of this or any other Warranty, expressed or implied whatsoever, even if the loss 
or damage is caused by the Company’s negligence or fault. Some states do not allow the 
exclusion or limitation of incidental or consequential damages, so the above limitation 
or exclusion may not apply to you. This Warranty gives you specific legal rights, and you 
may also have other rights which vary from state to state.

Please refer to insert for the Limitations of Fire Alarm Systems

PLASTIC LEVER

BREAK TAB AT

DOTTED LINE BY

TWISTING TOWARD

CENTER OF BASE.

USE SMALL-BLADED

SCREWDRIVER TO

PUSH PLASTIC LEVER

IN DIRECTION OF

ARROW.

SLOT

C0144-00

C1082-00

Figure 6a: 

Figure 6B: 

Содержание B200S

Страница 1: ...ensor synchronization protocol or a separate synchronization mod ule In this scenario the sounder bases will have the ability to synchronize with other System Sensor horns horn strobes and chimes using the same power source Specifications Base Diameter 6 875 17 46 cm Base Height less sensor 2 0 5 08 cm Weight 0 50 lb 227 gm Operating Temperature Range Refer to applicable sensor Operating Temperatu...

Страница 2: ...st feature has been activated insert a small bladed screwdriver into the slot from the top and press down on the lever see Figure 6B This allows the detector to be rotated counterclockwise for removal The tamper resist feature can be defeated by breaking and removing the plastic lever from the base However this prevents the feature from being used again Testing and Maintenance Sensors and bases mu...

Страница 3: ...OL RESISTOR VALUE EOL RESISTOR MAY NOT BE NEEDED FOR CLASS A WIRING E O L HORN HORN HORN STROBE C0474 07 C1090 00 NOTE The wiring diagram below represents the most common wiring configurations Please consult your FACP manufacturer for panel specific wiring configu rations and special cases Additional Audible Visible devices may be connected to the same power supply or the the NAC output of the Fir...

Страница 4: ...ee Year Limited Warranty Department RA __________ 3825 Ohio Avenue St Charles IL 60174 Please include a note describing the malfunction and suspected cause of failure The Company shall not be obligated to repair or replace units which are found to be defective because of damage unreasonable use modifications or alterations occurring after the date of manufacture In no case shall the Company be lia...

Отзывы: