This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery and recycling please return to your local designated
WEE/CG0783SS collection point as defined by your local council.
© 2022 System Q Ltd
2
Touch Sensitive Exit Buttons
Zap is a registered trademark of System Q Ltd
Document ref: qACC300-301
All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is
made to ensure that these instructions are complete and accurate, System Q Ltd cannot be held responsible for any losses, no matter how they arise,
from errors or omissions in these instructions, or the performance or non-performance of the equipment refered to.
Connections - ACC300-301
For operation with a door access control panel and lock, the exit
button is wired with NC or NO.
It also has a built in LED which requires 12V DC (not supplied with
the product).
Troubleshooting
If the exit button is not activating the lock then there is likely a shorted wire, open circuit or some
other failed device in the circuit.
To identify where the fault is, each wired connection in the circuit needs to be tested; working from
the push button progress through, including the keypad, the access controller, power supply and the
magnetic lock.
If the fault is with the access control button then check the connection wires for continuity and for
trapped wires. Check for water ingress on the wired connections. Check the polarity in the power
connections and ensure the connections are connected to the proper terminals.
Specification
ACC300/1
Construction
Plastic
Terminals
NO/ NC/ Common/ 12-24V DC/ GND (Wires)
Voltage
12-24V DC
Rating
3A 30V DC Max
LED Colour
Idle-Blue/Active-Green
Dimensions
86 x 86 x 20mm
