Systec & Solutions WAVE 224, Инструкция по эксплуатации

Страница: 21 / 41

4 Starting up
4.1 Unpacking the device
1.
Check the packaging for damage.
2.
Remove the packaging carefully to avoid damaging the contents.
3.
Check the device for damage.
If you find the packaging or the device to be damaged,
immediately inform the haulage company and the
supplier. Document the damage in some appropriate
way (e.g. incoming goods report, photos).
4. Check the delivered goods against your order and the delivery
papers to make sure everything is present and correct.
5.
Retain the original packaging.
Retain the original packaging so that it can be reused
for
– storage,
– transport and
– return for disposal
as and when necessary.
If you fail to do this it will no longer be possible to guar-
antee protection from damage or other harmful influ-
ences.
4.2 Setting up the device
1.
Prior to initial commissioning:
n If necessary, disinfect the device (spray or wipe with disinfec-
tant) (refer to the device’s chemical resistance
data Ä on page 26 ).
n
Slowly acclimatize the device to room temperature.
2.
In the event of condensation: Do not switch the device on until it
is absolutely dry.
3.
To avoid overheating during subsequent operation:
n
Do not expose the device to solar radiation or other sources
of heat
n
Make sure the ambient temperature does not exceed the
specified maximum value (see Ä Chapter 3.3 “Technical data
for the device” on page 13 ).
When installing the equipment also observe Ä Chapter 3.4 “Dimen-
sions” on page 15 .
Starting up
Setting up the device
WAVE 224 monitor/thin client - Industrial monitor/thin client 21