Protouch-wide: user documentation
DOC/PROTOUCH-WIDE-R; V1.1
DOC_PROTOUCH_WIDE-R_V1.0.docx
Seite 8 von 41
© 2018 Syslogic Datentechnik AG | All rights reserved
1.8.4
Battery
Maintenance of battery
Empty batteries may leak.
Check battery status flag and replace the battery to avoid loss of date (RTC) and
damage to the product.
Changing batteries
Danger of explosion if the battery is not correctly replaced. Replace only with the
same or equivalent type recommended by the manufacturer.
D
ispose of used batteries according to the manufacturer’s instructions.
Never short the battery.
1.8.5
Hot surface
Attention! Hot surfaces
Make sure the device is not hot before mounting or changing the installation. The
device may be hot and may cause burs.
1.9
Life Cycle Information
1.9.1
Transportation and Storage
During transportation and storage the products must be in their original packing. The original packing contains an antistatic bag and shock-
absorbing material. It is recommended, to keep the original packing in case of return of the product to the factory for repair. Note that the packing
is recyclable.
1.9.2
Assembly and Installation
Observe the EMI-precautions against static discharge. Carefully read the installation documentation before unpacking the product.
The installation procedures must be strictly observed. Note that deviations from the installation guidelines may result in degraded operational
reliability or in unfavourable EM-radiation or EM-susceptibility.
1.9.3
Operation
The operating environment must guarantee the environmental parameters (temperature, power supply, etc.) specified in the technical
specification section of this document.
The main functionality of the product is defined by the application program. The application program is not part of the delivery by Syslogic but
is defined, developed and tested by the customer or a system-integrator for each specific application. Refer to the respective documentation for
more information.
1.9.4
Maintenance and Repair
In the rare case of a product hardware-failure or malfunction, the complete product should be exchanged. The faulty product must be returned
to the factory for repair. Please use whenever possible the original packing for return of the product (EMI and mechanical protection).
1.9.5
Disposal
At the end of the lifespan the PROTOUCH products must be properly disposed. PROTOUCH products contain a multitude of elements and must
be disposed like computer parts. Some of the PROTOUCH products contain batteries which should be properly disposed.
