Quick Installation Guide
C. Connect connection cable and network lines.
D. Fit the screw holes of the mount base into the plastic anchors.
E. Remove the conduit knockout punched for the cable entry.
F.
Screw up the mount screws (M5x20).
G.
Adjust the camera suitably using the pan & tilt function, and fasten and fasten the mount
screws (M6x16) to fix the camera.
2. Installation
2.1 Connection
• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
Micro SD memory slot on the Rear Board
Remove the rear cap of the camera to insert the SD memory card.
•
Connecting the Power
Connect the power of DC12V for the network camera. Connect the po) pole to the ‘+’
position and the negative(-) pole to the ‘-‘ position for the DC power.
Caution: If using PoE, the heater will not operate at all.
• Connecting Service Monitor Port
Service monitor port is used for an easy OSD setup. To make changes in the OSD menu, please
use the OSD controller provided optionally with your camera purchase. You can set Camera Title
and IP Address.
6
