Instructions of Use and Maintenance LEX Plus 10 Connect Water Softener
18
When using the LEX Plus 10 Connect Single Water Softener, open
the bypass valve again,
vent the pipe at a close draw-off point and
re-plug the device.
Restart the device and observe the steps of the instructions „Installation
and Start-Up“, chapter „Start-Up“.
Verify the inlet water and blended water hardness and adjust the
settings if required.
Record the maintenance works in the maintenance report
(chapter 14).
Montage und Inbetriebnahme
LEX Plus 10 Connect
Einzel
enthärtungsanlage
A N L E I T U N G
7.2.5 Restart
Remove the filling level unit.
Verify the float and the check valve of the brine line – clean, if necessary.
Clean the salt tank and remove any incrustations or residues.
Remove the remaining salt from the salt tank and store it temporarily
as hygienically as possible.
We recommend for instance a clean plastic container, disposable
garbage bags, etc.
After cleaning, put the collected salt back in the tank.
Re-assemble in reversed order.
