Synthesis Technology MOTM-485 GX-1 Diode VCF, Инструкция по сборке и руководство пользователя

Страница: 11 / 20

PART #8: FINISH WIRING TO THE PANEL
Please read the following instructions carefully. In order to neatly attach the many wires to
the front panel components, the wires are soldered in a specific order. You may find, in
some cases, it is easier to first remove a jack from the panel and solder the wires, then
reattach it to the panel.
Mount the 2 switches in the panel. The larger DPDT switch goes in the top hole
(marked HP/LP) and the SPDT switch (3 lugs) goes in the lower hole (marked F/H).
In both cases, the rear nut needs to be tightened all the way, then “backed out”
¼ turn. Put on the toothed lockwasher, insert the switch so the handle toggles
up/down in a straight line, then place a nut on the front and tighten. The lockwasher
always goes on the back side of the panel. There is no top/bottom orientation for the
switches, just be sure they are straight.
Solder the white/gray/orange wire SW1 to the SPDT switch. The Orange wire goes
on the Top lug, the Gray wire to the middle lug and the White wire to the bottom lug
(hopefully the same order they are in the 3 holes on the pcb!)
Solder the white/gray/orange wire in SW2B to the lower set of 3 lugs of the DPDT
switch (the set nearest the pcb). Orange on the top, Gray on the center and White on
the bottom lug. Now repeat with the 3 wires in SW2A, soldering to the upper set of 3
lugs. Use a tie-wrap to bundle the 6 wires together in the middle of the wires.
Solder the short coax in J5 to the IN 1 jack. The braid goes to the beveled (ground)
lug and the inner conductor goes to the right lug (the top lug is not connected). Use
just enough solder so that the hole in the lug is filled with solder. All 3 coax wires
attach in this manner.
Solder the short coax in J6 to the IN 2 jack.
Solder the red/black wire in J2 to the FM IN jack. The black wire goes to the beveled
lug, the red wire to the left lug.
Solder the orange/white wire in J1 to the 1V/OCT jack. The orange wire goes to the
beveled lug, and the white wire goes to the left lug.
Solder the white/black wire in J3 to the RES CV jack. The black wire goes to the
beveled lug, and the white wire goes to the left jack.
Solder the long coax in J4 to the OUT jack (braid to beveled, inner wire to left lug).
Use the remaining tie-wrap to bundle the wires to the jacks.
Rotate all of the front panel pots fully counter-clockwise. Locate the KNOBS.
Notice each knob has a white line on it. Place the knob on the pot shaft,
SYNTHESIS TECHNOLOGY PAGE 11
MOTM-485 ASSEMBLY 8/11/05
WWW.SYNTHTECH.COM