P/N 01023650 Rev C
1
Page
4
2260-05
DLC Single Shroud
User Instructions
WARNING
Refer to Users
Instructions
(P/N 03521015)
for details
on chargers
and charging
batteries.
The entire CAPR System may be
decontaminated, cleaned and/
or stored at this time.
Doffing
!
10. Pull neck ties around to front, tie securely,
leave about a ½ inch gap between neck and
Shroud. Pull waist ties around and tie in front.
8. Continue pulling Shroud
down all around.
9. Don outer body gown
under the shoud per gown
manufacturer’s instructions.
8. Disconnect the Battery
Belt from around the
waist by un-snapping
the buckle.
9. With Charger connected to safe
power source, connect Charger
Cord to the Battery. Push Charger
Cord Connector into Battery
Receptacle until fully seated.
7. Disconnect the Helmet Power Cord
from the Battery - push the Secure
Connection Button down, pull Cord
Connector out, release the Button.
1. Untie and remove
body ties and
discard.
5. Loosen headband
Ratchet Knob
(counterclockwise).
2. Roll the Shroud up from the back,
into itself, over the Helmet top.
A. Unsnap rear snap. B. Unsnap
side snaps.
4. Doff the outer
body gown per
manufacturer’s
instructions.
WARNING
Discard ties,
Shroud,
and body
gown per
Institutional
protocol for
contaminated
waste.
!
6. Lift the Helmet up and off
the head.
3. Pull the Shroud fully
off and in front of
the Helmet and
discard.
A
B
