SynQor Headquarters UPS-1500-S-2S Series, Руководство оператора

Страница: 47 / 60

Section VI Control Interface Details
006-0007068 UPS-1500-S-2S Guide Rev E 47 of 60 09/10/20 www.synqor.com
Digital Input/Output Control Signals
There are 2 input and 5 output digital signals available on the User I/O female high-density DB15
connector. The pin assignments and functions of these digital I/O signals are as follows:
Signal Pin Number Function
+5 V 8
Bias voltage with minimal current drive usable as a pull-up voltage
for the open collector output signals (100Ω source resistance)
GND 4 and 5 Ground reference for all digital inputs and outputs
LOW_BATT 6
Open collector* output where “low” indicates battery charge
level is <10%
ACIN_GOOD 7
Open collector* output where “low” indicates AC Input voltage is
within range
ON_BATT 9
Open collector* output where “low” indicates the UPS is drawing
power from its battery
OUT_OK 14
Open collector* output where “low” indicates AC Output voltage
is within range
OVER_TEMP 15
Open collector* output where “low” indicates that the UPS is at
or above its maximum temperature
REMOTE_START 12 Drive this line “high” with ≥ 5mA to enable the UPS outputs
SHUTDOWN 13 Drive this line “high” with ≥ 5mA to disable the UPS outputs
*with an internal 50 kΩ Pull-up Resistor to 5 V and ESD Protection Diodes.