IL-RC2 USER GUIDE
SETTING EXAMPLE
Applying the following settings to all luminaires in group 5.
1. Dimming from 100% to 50%
2. Switch on the motion sensor
3. Medium detection distance
4. Night mode
5. Time to standby in 3 minutes
6. Standby Brightness 10%
Medium
3 min
10%
1.
3.
4.
5.
6.
2.
Night
To apply settings to multiple groups at the same time, first press and hold the numbers of the
desired groups (in this example 1, 3 and 5). Then take the same steps as above.
1
3
5
GROUP
Select and manage a group or multiple groups at the same time.
SYNCHRONIZE
Synchronize personal settings to a group or multiple groups at the same time.
BRIGHTNESS SETTINGS
Set the brightness to minimum, maximum or dim on a gradual level.
MOTIONSENSOR SETTINGS
Turn motionsensors on or
Set motion detection distance to 3, 5 or 8 meters.
Set the ambient light detection level to dusk or night or switch it off.
Set the time mode to 30 seconds, 3 minutes or 10 minutes
Set standby brightness to 10%, 30% or switch it off completely.
Stand directly under the luminaire and point the remote control
directly at the sensor.
Point at luminaire
in group 5
Point at luminaire
Press
Longer
Press
Longer
Press
Longer
Light On & Off
Standby brigtness
Dim down % when standby mode
Brightness
Dimming up & down
3m, 5m, 8m sesning distance selection
Motion sensing distance
Grouping
Motion sensor On & Off
Enable & Disable the motion
sensor function
Select “All” group or
Individual group for control & setting
Sync command
Sync the same commond to
the same group of panel
Individual group
Select any group for control & setting
Reset
Reset the grouping
Ambient light sensing level
Certain time setting for standby mode
Standby time
Not available
