IL-RC2 USER GUIDE
FACTORY DEFAULT SETTING:
Luminaires are by default not
classified in a group
Grouping = 0 (no group),
Brightness = 100%,
Motion sensor ON,
Sensing distance = Near (1-3m),
Ambient light = OFF,
Time until standby = 10min,
Standby brightness = OFF
GROUPING
Stand directly under the luminaire and press
the desired group number longer, the lumi-
naire flashes once and it has been set to the
desired group. Repeat this with all fixtures.
SELECTING A GROUP
With the button you can switch all luminaires from all groups on or off.
Press the number of the desired group to only switch on or off the luminaires from the same
group.
SYNCHRONIZE SETTINGS
To assign a setting to a whole group of luminaires, take the following steps:
1. Stand directly under a luminaire from the desired group and select the desired setting
→
the luminaire flashes briefly.
2. Press
→
all the luminaires flash briefly
3. Hold the button for some time
→
alle panelen knipperen. all panels flash. The cho-
sen setting now applies to all luminaires in the group.
All
Select
SETTINGS
DIMMING
press to dim the luminaires gradually (in steps of approx. 12.5%),
press MIN to switch to the lowest dimming position (± 12.5%), press MAX to switch to the
highest setting (100%) .
MOTION SENSOR
press to activate the sensor or to switch off the sensor.
DISTANCE
Set the range of the sensor. Choose from near (1-3m
radius), medium (4-6m radius) or far (7-9m radius). Radius is based on a sensor height of 2.8
meters. For optimal results choose the Far setting.
TIME UNTIL STANDBY
Select the desired time period after
which the lighting should go into standby mode (30 seconds, 3 minutes or 10 minutes). Be-
fore the luminaire goes into standby mode, the luminaire dims to 50%, after 30 seconds the
luminaire changes to standby mode.
STANDBY BRIGHTNESS
Choose between off (light off), 10% or
30%.
RESET
hold button to return luminaire to base setting.
Near
Medium
Far
30 Sec
3 min
10 min
Off
10%
30%
