12
Chapter 2: Hardware Setup
To replace the long bracket with the short one:
1
Remove the two screws holding the longer bracket to the interface card. Then remove the bracket as indicated
below.
2
Replace the longer bracket with the shorter one from your RackStation. Then tighten the two screws to secure
the shorter bracket.
To install the network interface card:
1
Follow steps 1 to 2 of “Install a RAM Module” on Page 9 to remove the cover from your RackStation.
2
To install the network interface card, follow the steps below:
a
Remove the screw on the port access cover. Then remove the access cover.
b
Align the card connector with the expansion slot and insert the card into the slot.
Important:
c
Tighten the screw to secure the network interface card.
Make sure the connector is completely inserted. Otherwise, the network interface card might not
function properly.
