Assembling the Corzino
The instructions in the User Guide will guide you through the assembly process of the positioning
seat. However, it is recommended that the initial adjustment for the user be done in the presence
of a Synetik ErgoCare representative.
NOTE! The numbers in parenthesis refers to the schema presented on page 6.
Hex Key
Only one Hex key is needed to assemble and adjust the Corzino Stroller. It is located in a pocket
on the bottom left corner of the back of the backrest.
Opening the Stroller
To complete the assembly, you need to;
1. Stand stroller on its wheels
2. Unlock the transport safety latch (12)
3. Grasp one handle (1) and push down on the opposite seat tube (22), press down firmly on
seat tubes to ensure the stroller is completely open.
4. Use foot to lock the rear brace into a straight position
5. Wrap the armrest padding around the armrests (25)
6. Mount the footrest onto the stroller. (see footrest installation section)
7. Lock the seat brace—Sizes 38–42 only
Footrest Installation
Install;
1- Loosen the footrest adjusting lever (16)
2- Insert the footrest tube into the footrest opening until itreaches the safety pin (21)
3- Pull the safety pin while pushing on the footrest
4- Release the safety pin and pull gently on the footrest until it stops at the lowest position
5- Tighten the adjusting lever
6- Repeat for the second footrest.
Height Adjustment;
1- Loosen the adjusting lever (16)
2- Pull the safety pin towards you (21) and adjust the footrest into desired position
3- Release the safety pin and tighten the adjusting lever to secure the footrest in position
4- Repeat for the second footrest.
Uninstall;
1- Loosen the adjusting lever (16)
2- Pull the safety pin towards you (21) and pull the footrest tube out of the opening
3- Release the safety pin and retighten the adjusting lever
4- Repeat for the second footrest.
8
Содержание CORZINO
Страница 1: ... USER GUIDE CORZINO V1 2019 02 07 ...