SimplySNAP
Continued
Page 4
SimplySNAP Quick Install Guide
To retrieve a DHCP assigned IP address:
1. Connect to the site controller via WiFi as
described above and log in.
2. Click the
Config
menu item in the left menu
bar, then click the
System Info
tab near the
top of the screen.
3. The site controller IP address is shown in
the field labeled
Ethernet IP Address
. This
address may be entered into a web browser’s
address bar and used to connect to the site
controller across a wired LAN.
NOTE:
A network administrator can configure the DHCP server to always provide the same IP
address to the site controller and ensure connectivity can always be established via the LAN.
Basic Site Configuration
After establishing connectivity to the site controller, the following steps should be taken to initially
configure the system for controlling lights.
Configure the site controller’s location and time:
The location of the site controller may be entered by
navigating to the
Config
page, clicking the
Location &
Time
tab, and entering the correct longitude and latitude.
The system time and time zone may also be entered in the
Location & Time
tab.
After entering this information, click
Save Changes
at the
bottom of the page.
If the site controller is connected to the internet via a LAN
connection, the Map page will display the correct location of
the site controller on a map overlay.