9
SAE LOW BEAM “
VOL
” (Visual Optical Left):
Low beam lamps manufactured after 1999, some
vehicles. The high intensity area is located in the
lower right hand quadrant and the beam pattern is
aligned by placing the left upper portion of the beam
pattern on the .4 Degree (2.096”) Down Horizontal
axis.
4.4 ALIGNMENT OF HEADLAMP PROCEDURE
1.
Locate
BCA 4
ISO
Color
approximately 12 inches
from in front of the lamp to be aligned. Placement can
be 6” to 18” without jeopardizing alignment.
2.
Position
BCA 4
ISO
Color
in front of first lamp to be
aligned. Centering of system on headlamp is very
forgiving, as the fresnel lens provides a 1.5” widow
for centering.
3.
Align
BCA 4
ISO
Color
to vehicle by sighting
through the sighting unit and rotating optical head
until line in sighting unit intersects the two common
points selected.
4. Headlamps should be switched on to low beam as this
is the primary driving lamp.
a.
In compound lamps, where the Low Beam
and the High Beam are in the same lamp,
you only align one pattern, as by law, the
other pattern must be within 1.5” of perfect
alignment.
5. While viewing aim screen, adjust headlamp to position
that appears as graphic illustration of headlamp pattern
selected. The most inner portion of color is the high
intensity zone and this is what you center over the white
designated for the lamp pattern selected.
NOTE: Graphics on aiming screen denote position
of lamp position in inches.
6. Repeat steps for remaining lamps.
6.
LASER CALIBRATION / MAINTENANCE
5.1 FLOOR SLOPE LASER CALIBRATION
“LASER IS CALIBRATED AT THE FACTORY PRIOR TO SHIPMENT”
“Calibration Required
ONLY
if Rear- LASER Adjustment Set Screw has
been tampered with”
Tools Required:
Elevated Surface
(wheel alignment, frame machine)
Level
(carpenters level or other means)
6‘ Straight Edge
(board or other means)
5/64” Allen Wrench
H
V
US Low Beam
VOL
.4 Degree Down
(2.096 Inches)
Aim Area
1. Position “BCA 4” in Front of first
lamp to be Aligned.
2. Adjust Floor Slope to Recorded
Bay Setting.
3. Square BCA 4 to Vehicle by
Looking Trough Sighting Unit.
Headlamp Alignment Procedure
4. Aligning Two Common Points with
Line in Sighting Mirror.
5. Select Lamp Beam Type. While
viewing Lamp Patten, Adjust
Lamp to Pictorial Position
6. Move BCA 4 to Next Lamp and
Repeat Steps 3 Through 5.
Содержание BCA4
Страница 2: ...2...
