FIBERGLASS WALL
INSTALLATION
When installing Visu-Temp in fiber-
glass or panel walls and it is desired
to sandwich wall between valve
body and escutcheon, cut hole in
wall as shown in Figure 4 and mount
valve from rear. NOTE: IT IS ALWAYS
RECOMMENDED TO SECURE VALVE
PIPING TO ROUGH CONSTRUCTION
AND NOT DEPEND ON FIBERGLASS
WALL FOR VALVE MOUNTING SECU-
RITY. On panel walls over 1” thick,
install in conventional manner. (See
figure 1).
OPERATION OF VALVE
The main handle of the Visu-Temp
valve is for control of temperature
only. From the OFF position, the
handle is turned counter-clockwise
through a minimum cold position,
through a warm and hot position for
a maximum turn of approximately
one revolution. This allows for infi-
nite temperature adjustments to suit
the requirements of any user.
CARE AND CLEANING
The lustrous finish on your Visu-Temp
valve should be treated with care. It
can be readily damaged by improper
handling or abusive treatment. To
clean the finish wipe gently with a
soft damp cloth and blot dry with a
soft towel. Use only a mild soap solu-
tion if required. DO NOT USE ABRA-
SIVE CLEANERS. USE OF POLISH,
ABRASIVE CLEANERS, SOLVENTS OR
ACID CLEANERS WILL DAMAGE THE
FINISH AND VOID THE SYMMONS
WARRANTY.
INDIVIDUAL PARTS
C-5
Spindle assembly
C-32-11
Spindle assembly
C-32B-11 Plaster shield
SC-2
Cap
SC-3
Renewable seat
SC-7
Packing nut with o-rings
SC-9
Cold washer retainer
SC-10A
Hot washer screw
SC-10/11 Hot and cold washers
SC-13/18 Dome cover and lock nut
SC-15A
Handle screw
SC-17
Packing
SC-19
Cap gasket
SC-20A/21 Top seat O-ring & bottom seat
gasket
SC-26
Limit stop with o-ring
SC-126
Plaster shield
VT-4P
Thermometer test probe plug
VT-9A
Retainer assembly
VT-105
Escutcheon assembly
VT-103
Thermometer assembly
VT-104
On/Off indicator assembly
VT-112
Handle
WO-20A Escutcheon screws (2)
Washer & Gasket KIT-B-VT
SC-9
Cold washer retainer
SC-10A
Hot washer screw
SC-10/11 Hot and cold washers
SC-15
Handle screw
SC-17
Packing
SC-19
Cap Gasket
VT-9A
Retainer assembly
VT-114
Escutcheon gasket
Repair units
SC-3
Renewable seat unit complete
C-50
Renewable seat socket wrench
(not shown)
C-5
Spindle assembly
COMPOSITE PARTS
SC-13
VT-112
SC-15A
VT-105
SC-130
T-149
VT-103
WO-20A
VT-104
SC-7
SC-17
SC-26
SC-19
SC-10/11
C-5
SC-20A-20
C-32-11
VT-9A
VT-4P
SC-10A
SC-3
SC-9
SC-2
SC-126
TO BE DISCARDED BEFORE INSTALLING TRIM
C-32B-11