Symmetry Office APEX-SYMAC Series, Руководство по установке

Страница: 7 / 16

Installation Instructions APEX-SYMAC Series
7
Assembly And Installation
Connecting Desk Clamp Arms to Desk
Standard Installation
1. Loosen clamp screw until enough space is created between
clamp and mount to allow for desk mounting. (See Figure 1)
NOTE:
If space is limited behind desk (i.e. against wall, etc.),
remove lower piece of clamp and two screws holding it
to the mount and reattach parts prior to Step 3! (See
Figure 2)
2. Place mount on top of desk at desired mounting location.
(See Figure 1)
3. Tighten clamp using clamp screw until mount is securely
fastened to desk. (See Figure 1)
Figure 1
Figure 2
Grommet Hole Option
NOTE:
APEX-SYMAC Series mounts may be installed directly
to grommet holes between 1 1/4” and 2 1/2” in
diameter. If grommet hardware (F-H) is used, they can
be installed to grommet holes between 3/8” and 2 1/2”
in diameter.
Direct Installation
1. Remove lower piece of clamp from assembly by removing
two button head cap screws holding piece to assembly.
(See Figure 3)
2. Install remaining part of clamp through grommet hole. (See
Figure 3)
Figure 3
3. Reattach removed piece of clamp and screws to assembly.
(See Figure 4)
4. Tighten clamp using clamp screw until mount is securely
fastened to desk. (See Figure 4)
Figure 4
1
2
3
desk
(APEX-SYMAC1 shown)
2
x 2
1
x 2
4