Symmetry Office APEX-SYMAC Series, Руководство по установке

Страница: 12 / 16

APEX-SYMAC Series Installation Instructions
12
Array Bar Roll Adjustment
1. Loosen roll adjustment screws on back of array bracket.
(See Figure 19)
2. Adjust roll of array bar as desired. (See Figure 19)
3. Tighten roll adjustment screws on back of array bracket.
(See Figure 19)
Figure 19
Display Removal
WARNING: Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 20)
1. Make sure display is in the upright position.
2. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 20)
Figure 20
Pivot Adjustment Range
APEX-SYMAC1
1. Adjust arm angle as desired up to 90 degrees in either
direction. (See Figure 21)
WARNING: Swinging the arm beyond 90 degrees may
result in the mount slipping off the desk causing serious
injury!
Figure 21
1
3
2
2
quick release tab
2
(top view)
+/- 90 degrees range
of motion
pivot point of the arm