A1
User’s Guide
6200 Digital
Voice Processor
To download the latest version of 6200 Designer, a Windows GUI
application interface for the 6200, go to: www.airtoolsaudio.com
TM
Symetrix
Engineered by
Appendix A - Mic Level Output
Mic Level Output
If you find it necessary to connect the 6200’s line level output(s) to a microphone level input, you will need to sufficiently
attenuate the 6200’s outputs using internal jumpers.
WARNING
Lethal voltages are present inside the chassis. Perform all service work with the unit
disconnected from all AC power.
CAUTION
These servicing instructions are for use by qualified personnel only. To avoid electric shock, do not
perform any servicing other than that contained in the operating instructions portion of this manual unless
you are qualified to do so. Refer all servicing to qualified service personnel.
Tools Required
1. #2 Phillips-head screwdriver
Top Cover Removal
1. Ensure that the 6200 is disconnected from the AC power source.
2. Remove seven 6-32 x 1/2 inch screws from the top panel and two 6-32 x 1/2 inch screws from each side of the
chassis.
3. Lift the top cover free of the chassis.
Changing the Output Level Jumpers
The 6200 ships with the outputs configured for a line level output. If you must have a microphone level output, the following
steps lead you through the process of switching one or both line level outputs to microphone level (or back to line level).
1. Remove the top cover according to the steps outlined above.
2. Locate the output level jumpers J4 and J5 next to Channel 1’s Analog Out jack and jumpers J7 and J8 next to
Channel 2’s Analog Output jack.
3. To convert Channel 1 Analog Output to mic level, place jumper J4 in the 2-3 position and jumper J5 in the 1-2
position.
4. To convert Channel 2 Analog Output to mic level, place jumper J7 in the 2-3 position and jumper J8 in the 1-2
position.
4. Replace the top cover.
5. Reinstall the 6200 into your setup.
Содержание airTools 6200
Страница 32: ......
