Symbol Phaser P460, Справочное руководство

Страница: 21 / 147

3-2
Phaser Series Scanner Product Reference Guide
After 10 seconds, the System Banner is replaced by the system initialization screen:
SYMBOL TECHNOLOGIES
INITIALIZING ...
Figure 3-2. Initialization Screen
and finally (after about 5 seconds of initialization), the scanner enters either the BATCH
scanning screen or the POS scanning screen, depending on whether the unit is attached to a
communications cable or not.
Batch Application
The default Batch application is a simple scan-and-store application which allows you to scan
or key in a bar code. The screen appears as follows:
SCAN: _______________
_____________________
Figure 3-3. Batch Application Screen
Scanned bar codes are accepted automatically, and after a brief (3 second) delay, the screen
clears to accept the next entry. (However, data entry may proceed before the 3 second pause.)
Keyed bar codes must be completed with the <ENTER> key. After keying a bar code, the field
clears immediately for the next entry. During key entry, the <BK> key will correct keying
errors digit by digit, and the <FN><BK> combination will clear the field so you can start over.
If the data you are entering exceeds the visible length of the field (i.e., more than 34
characters), then characters scroll off the left end of the field, but are retained for storage.
If the scanner powers down at any time during the default application, pull the trigger or
press the <ENTER> key to wake it up again.
Data Review
At any time during the Batch operation, you can review the stored data. Press the <*> key to
show this screen:
CODE: xxxxx
nnnn/nnnn
Figure 3-4. Data Review Screen