5
Q
u
i
c
k
R
e
f
e
r
e
n
c
e
Scanning in Hands-Free (Presentation) Mode
To place the LS 6000 scanner in the optional hands-free
Presentation Stand, slide the rubber “chin” support on the scanner
into the notch in the stand until the scanner is firmly seated. The
scanner emits a constant-on omnidirectional pattern. To scan a
bar code, bring the bar code anywhere within 10 in. (25.4 cm) of
the scanner window for a successful decode. Bar codes can either
be directed in toward the nose of the scanner (“presentation”
scanning) or from side to side in a sweeping motion (“swipe”
scanning).
When the LS 6000 is removed from the Presentation Stand, the
scanner operates in the programmed trigger mode (see
for
trigger mode descriptions).
Selecting Beeper Volume
The LS 6000 emits a short beep when it successfully reads a bar
code. There are three volume settings for this decode beep. To
change the setting, hold down the trigger for five seconds. The
scanner cycles through three settings, emitting a 2-beep tone at
each setting. To select a particular setting, release the trigger after
the desired 2-beep tone.
To adjust the frequency (tone) of the scanner’s beeper, see
.
Inserting LS 6000 into Stand
Scanning in the Stand
Содержание LS6004i-I000
Страница 1: ...L S 6 0 0 0 S e r i e s...
Страница 18: ...16 L S 6 0 0 0 S e r i e s Numeric Bar Codes Cont d 4 5 6 7...
