Symbol AP-5131, Руководство по установке, Страница: 14 / 48

AP-5131 Access Point: Installation Guide 10
To install the Power Injector to an Ethernet data source and AP-5131:
1. Connect the Power Injector to an AC outlet (110VAC to 220VAC).
2. Connect an RJ-45 Ethernet cable between the network data supply (host) and the Power
Injector
Data In connector.
3. Connect an RJ-45 Ethernet cable between the Power Injector Data & Power Out connector
and the Symbol AP-5131 LAN port.
Ensure the cable length from the Ethernet source (host) to the Power Injector and AP-5131
does not exceed 100 meters (333 ft).
The Power Injector has no On/Off power switch. The Power Injector receives power and is
ready for AP-5131 device connection and operation as soon as AC power is applied.
CAUTION Ensure AC power is supplied to the Power Injector using an AC cable
with an appropriate ground connection approved for the country of
operation.
NOTE
Cabling the Power Injector to the AP-5131’s WAN port renders the
AP-5131 non-operational. Only use a AP-BIAS-T-1P-AF model power
injector with the AP-5131’s LAN port.
!