SYMA X600W, Инструкция по эксплуатации

Страница: 11 / 16

-10-
3m
One-touch take-off/landing
1
.
When the aircraft is in standby, press the
take-off button to make the aircraft take off
automatically and hover at a height of1.5 m.
2
.
When the drone is in the air, press the
one-touch take-off/landing button to make
the aircraft land automatically.
Stunt functions
Undervoltage
Level calibration
High/low speed mode
Undervoltage protection
A flashing red indicator light on the base of the aircraft indicates that
the battery level is low. When this occurs, bring the aircraft back to
land.
Overcurrent protection
If the aircraft’s blades collide with another object or become stuck,
the aircraft’s circuit will engage the overcurrent protection
mechanism.
Place the aircraft on a level surface and
move the left and right joysticks to the
lower right corner for approximately 3
seconds. The indicator will flash rapidly
and then stay constant to indicate that
the calibration process is complete.
Briefly press the right joystick to switch
between high and low speed mode.
1
.
Low speed mode is enabled by default
when the aircraft is switched on.
2
.
The remote control beeps twice when
high speed mode is enabled and once
when low speed mode is enabled.
Once you have mastered the basic
controls, you can try performing some flip
manouevres. Start by flying the drone to
an altitude of at least 3 m. Then hold
down the button on the top-right corner of
the remote control (flip button) and push
the right joystick all the way
up/down/left/right to flip the aircraft
forward/backwards/left/right.
English