Sylvania SRM931-2628DC, Инструкция по эксплуатации, Страница: 3 / 7

3
Fig. B
Step 3: Attach Left front panel [D] and Left side panel [F] to Base [B]with 2 KD
screws. Attach Right front panel [E] and Right side panel [G] to Base [B] with 2 KD
screws. See Fig. C.
Fig. C
Step 4: Attach Front panel [C] to Panel D, E, F and G with 6 KD screws as shown in
Fig D. Attach 1 plastic connector to Front panel [C] with 2 KD screws. See fig. D
Fig. D
Step 5: Attach Top panel [A] to the unit as shown in Fig E, with 3 KD screws.
See fig. E
Fig. E
Step 6: Tighten all KD SCREWS.
FIREPLACE INSERT INSTALLATION:
The fireplace insert can be installed after the mantel has been fully assembled.
WARNING:
Make sure the fireplace insert controls are in the OFF position and the
unit is NOT plugged in.
Step 1: Carefully place the INSERT in the unit opening. The front of INSERT should be
flush with the front of the mantel. Carefully lift the INSERT into the mantel until the
top stopper is against the mantel.
Step 2: Attach 2 Mounting brackets [T] at the top side of insert with 3 KD screws.
Attach 2 Mounting brackets [T] at the bottom sides of insert with 2 KD screws.
See Fig. F
Fig. F
Step 3: Move assembled unit to desired location. Unit should not be positioned in
area exposed to direct sunlight.