4
Step 2: Carefully lift the insert into the mantle opening. The front of the INSERT should
be flush with the front of the mantle. See fig. I
Fig. I
Step 3: Once the INSERT is in place, attach 4 MOUNTING BRACKETS (V) to the bottom
with 4 MED-KD SCREWS (W). See fig. J
Fig. J
Step 4: Attach 2 MOUNTING CLIP (U) on the top of the INSERT. Attach 4 MOUNTING
SCREWS (S) with the INSERT as shown in Fig. K and 2 SHORT KD SCREWS (T) with the
MANTEL UNIT as shown in Fig. L
Fig. K
Fig. L
Step 5: Move assembled unit to desired location. Unit should not be positioned in an
area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE is highly recommended in order to reduce
the risk of the fireplace being tipped over accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace is improperly handled, but is not a
substitute for proper adult supervision. Children should not be left unattended near
any heater.
1. Drill a 5/16” (8mm) hole in the wall. Insert the PLASTIC WALL ANCHOR into the
hole and gently tap until the flange on the anchor is against the wall surface.
2. Position the back edge of the mantle close to the wall.
3. Attach the SAFETY CABLE to the mantle using the SCREW FOR MANTLE. See fig. M
4. Use the SCREW FOR WALL to attach the other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
Fig. M
Once the fireplace heater has been properly installed to the mantel, plug the fireplace
into a 15AMP/120 Volt outlet. If the cord does not reach you may use an extension
cord rated for a minimum of 1875 WATTS.
Note:
Every time the electric heater is plugged in, it will beep once. This means the
heater has connected to the power outlet. The Electric Fireplace Heater is ready to
operate. Note: ensure the circuit breakers for the power supply are turned on. The
electrical fireplace heater can be operated by the control panel and operated by the
remote control. See the following:
OPERATION BY THE CONTROL PANEL
ON/OFF:
Press this button for main power function. The unit will beep and the indica-
tor light will be on. Pressing again will stop the main power function. Once the heater
is switched off, the indicator light will flash and the unit will keep working with air flow
for 5 more seconds.
FLAME/LOG:
Press this button once for flame effect. The unit will be beep and the
indicator light will be ON. The bulbs for flame effect & log-set will be ON. To adjust the
flame intensity, hold down the button - the flame optics will go higher or lower. Once
you have found the desired setting, release the button. Pressing the button again will
stop the light function.
750W:
Press this button for low heat level. The unit will beep, the pilot light and indi-
cator light will be on. The fireplace heater will give low heat level. Pressing once again
will stop the low heat level function.