Sylvania SRCD1081BT, Инструкция по эксплуатации, Страница: 8 / 16

SETTING FM RADIO PRESETS
The
Bluetooth CD Radio Microsystem
can store up to 20 radio station
presets. To Manually Set Presets
1. Find the radio station you would like to save.
2.
Press the MEM/PROG button on the main unit or PROG button on the remote control.
3. Press
/ TUN- or / TUN+ buttons to select the preferred Preset Number,
The display will show
"P01, P02, etc..."
4.
Press the MEM/PROG button on the main unit or remote control again to save the station .
5. Repeat steps 1-4 until you have finished saving your presets.
6. To navigate through the stored presets, press the
MEM+ or MEM- buttons.
ADJUSTING THE VOLUME
VOLUME ADJUSTMENT
Twist the VOLUME KNOB to adjust the volume. The volume level will be shown
in the L
C
D Display in the top right corner of the unit.
NOTE: Depending on the type of music/audio output from the
Bluetooth CD Radio
Microsystem , the 2 Volume (VU) Meters might not move at lower volumes. In some
cases, the volume must be around “#20 or higher” to see very active movement.
BALANCE
Twist the BALANCE KNOB to adjust the volume between the left speaker and the
right speaker. The volume of the left speaker and right speaker is equal when the
BALANCE knob clip in middle
.
TREBLE AND BASS
Twist the TREBLE KNOB and BASS KNOB to adjust the treble and bass
levels.
6
LISTENING TO THE RADIO
1. Press the
SOURCE button to switch to the FM RADIO. The display will show a
radio station: “87.5”.
2. Tune to a desired radio station. The frequency is indicated on the display.
• MANUAL TUNING: Press the TUN+ or TUN- button briefly and the frequency
will tune up or down.
• AUTO SEARCHING: Press the TUN+ or TUN- button for more than 2
seconds, the radio frequency will start to change on the display. Once a
station is found, the radio will stop searching and start to broadcast
immediately.
3. Re-position the antenna if necessary.