3
OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15 AMP/120 Volt outlet.
OPERATION BY THE CONTROL PANEL
The controls are located at the left side behind the front glass.
LEFT sIdE
O/I:
Press this button for main power. The indicator light will be on. See below for other
control switches.
: Standby switch:
Press this switch once to turn on the fireplace. Press again to
turn off all functions and enter the standby mode.
: FLAME:
Press this button once for flame effect. The unit will be beep and the
indicator light will be ON. The bulbs for flame effect will be turn ON. To adjust the
flame intensity, hold down the button – the flame optics will go higher or lower.
Once you have found the desired setting, release the button. Pressing the button
again will stop the light function.
750W:
Press this switch while the 0/I and standby switches are in the ON position for
low heat. The indicator light will turn on. Press again this switch to stop the low
heat function.
1500W:
Press this switch while the 0/I and standby switches are in the ON position for
high heat. The indicator light will turn on. Press again this switch to stop the high
heat function.
NOTE:
When the O/I switch is turned OFF, all other heater functions will stop even
though the switches may be in the ON position.
OPERATION BY THE REMOTE CONTROL
Plug in your electric fireplace and turn the
“0/I” switch to “I” position. The unit will beep
once and your remote is ready to operate your
electric fireplace heater.
: Standby switch:
Press this switch once
the unit becomes energized and you can
select the following functions as desired.
Press this switch again, the unit will be off
and enter the standby mode.
: FLAME:
Press this button once for flame
effect. The unit will be beep and the
indicator light will be ON. The bulbs for
flame effect will be turn ON. To adjust the
flame intensity, hold down the button –
the flame optics will go higher or lower.
Once you have found the desired setting,
release the button. Pressing the button
again will stop the light function.
750W:
Press this button for low heat.
The unit will beep, the indicator light will
be on. The fireplace will give low heat
level. Press once again will stop the low
heat function.
1500W:
Press this button for high heat.
The unit will beep, the indicator light
will be on. The fireplace will give high
heat level. Press once again will stop
the high heat function.
REMOTE CONTROL BATTERY REPLACEMENT
Replace with 2 AAA batteries.
wARNINg: dO NOT MIx OLd ANd NEw bATTERIEs. dO NOT MIx
ALkALINE, sTANdARd (CARbON‑ZINC), OR RECHARgEAbLE
(NICkEL CAdMIuM) bATTERIEs.
MAINTENANCE
wARNINg: dIsCONNECT POwER ANd uNPLug THE POwER CORd bEFORE
ATTEMPTINg ANy MAINTENANCE OR CLEANINg TO REduCE THE RIsk OF
FIRE, ELECTRIC sHOCk OR dAMAgE TO PERsONs. THE buLbs IN yOuR uNIT
CAN bECOME ExTREMELy HOT. ALLOw AT LEAsT 10 MINuTEs bETwEEN
TuRNINg OFF THE uNIT ANd REMOvINg THE LIgHT buLbs TO AvOId THE
ACCIdENTAL buRNINg OF THE skIN.
RIsk OF FIRE: dO NOT ExCEEd THE RECOMMENdEd buLb wATTAgE.