Sygonix 2299890, Руководство по эксплуатации

Страница: 23 / 268

Do not disconnect the code lock from the power supply during
programming. This may result in memory errors and result in the
existing data/settings being lost. Note the following important
information:
• The master code is required to enter programming mode. By
default, the master code is "123456".
Digits for programming should be entered via the
buttons on the remote control.
• Each user can be assigned a specific user ID (this is a
number from 1 to 2000, without "0" at the beginning). The
adding and saving of transponders is also possible without
entering a user ID (the code lock assigns it automatically). In
this case, however, a specific user can only be deleted if their
transponder is still available.
• We therefore recommend that you also assign a user ID for
each transponder that you want to add to the code lock.
• The user ID should be recorded in a list together with other
data (employee name, access via transponder).
• Any standard EM transponder which works with a transponder
frequency of 125 kHz can be used as a transponder.
b) Entering/exiting programming mode
To enter programming mode, you need to enter the master code
using the IR remote control. By default (default factory settings or
after a reset), the master code is "123456".
23