MIG TORCH
ALUMMIG
230
1.
2.
3.
4.
5.
6.
7.
8.
CHANGING THE LINER
Disassemble the MIG torch swan neck parts.
Remove the liner retaining nut.
Lay the torch out straight, then carefully pull out and remove the existing liner.
Carefully feed in the new liner down the torch lead until it exits the torch neck.
Teflon Liner - Remove the small rubber o-ring and install the retaining nut to tighten
down. Remove the retaining nut and reinstall the o-ring, then lightly tighten. For
steel liners, install the retaining nut.
Snip the excess liner off at the end of the Gas Diffuser.
Replace the swan neck parts.
Fully screw down the liner retaining nut and nip it uptight.
1.
2.
3.
4.
5.
6.
7.
8.
