_____________________________________________________________________________________
SWS – 7695 Blackburn Parkway, Niagara Falls, ON Canada
Tel: 1-877-357-0222 | Fax: 905-357-9122 | [email protected]
300197 Rev. 2
Page
3
of
5
Intelligent Network (2079x Models Only)
Magnet Mount versions
do not
have the ability to connect to the intelligent network.
The BLUE and WHITE wires are used for the intelligent network to synchronize up to 16 lights. If the light is to operate independently or if there is only
one light present, these wires can be stowed away for future use if desired.
Choose a master. The master light will control the features of itself and all slaves in the network (dimming, pattern select etc.) to make the light a
master
; connect its WHITE wire with all other WHITE wires.
To make the light a
slave
, connect its WHITE wire with all other white wires and isolate and stow away its GREEN and VIOLET wires as the light will
take the pattern select and dim commands from the master light.
To make the slave light
synchronize
; connect its BLUE wire to the RED (POSITIVE) wire.
To make the slave light
alternate
, connect its BLUE wire to the BLACK (NEGATIVE) wire.
Intelligent Battery Monitor (2075x-2079x Models Only)
The Intelligent Battery Monitor is a factory-
installed feature that will detect the voltage across your vehicle’s battery. If your battery’s voltage goes below
11.5V, the light will switch to a unique alert pattern prompting you to start your vehicle to charge your battery. Once the battery goes above 11.8V, the light will
resume its previous operation.
To disable this feature, turn the power to the light off.
Hold the GREEN pattern select wire to ground/negative. For Mag. Mount lights, hold down the momentary pattern select switch.
With the pattern select wire/switch held to ground, turn the power on to the light.
Hold the wire/switch until the light flashes
once
. Release the pattern select wire/switch to disable the battery check feature.
To re-enable the feature, repeat the first three steps, but wait for the light to flash
twice
before releasing the pattern select wire/switch.
If you do not release the pattern select wire/switch after the double flash, the light will resume operation with whatever setting was present prior to
entering the selection process.
Trouble Shooting
If your light fails to work, please follow these troubleshooting tips before calling the factory:
Check all connections for breakage or corrosion.
Check to see if the fuse has blown within the vehicle. If it has, replace with a fuse of the exact same amp rating.
For long wire lengths, ensure the voltage at the light
’s connections is adequate. If not, you may have to shorten the length or increase the wire gauge.
Check power to vehicle cigarette plug receptacle (may have blown fuse / may require ignition to be turned on).
Check fuse in cigarette plug (access through threaded tip of plug). If fuse is blown, replace with fuse of exact same rating.
Ensure
vehicle’s battery is charged and that the charging system is functional.
CALL SWS CANADA (1-877-357-0222) FOR FURTHER ASSISTANCE
