Operating Instructions
www.snopakebrands.com
•
The laminator is equipped with a jam detection device. If there is a jam, the laminator will reverse itself automatically to
eject the jammed pouch. The laminator will shut down by itself when the jammed pouch is removed.
•
If the lamination pouch is jammed / misaligned before the jam detection device
is activated, press the
Roller Reverse
button manually and pull the jammed /
misaligned pouch out of the laminator
gently
. Forceful pulling may damage the
laminator.
•
If the
Roller Reverse
button is pressed when the laminated item has reached the
exit, the laminated item will go towards the outlet. This is a safety measure
to protect the laminator.
•
After the jammed pouch is removed from the laminator, release the
Roller
Reverse
button and continue with a fresh lamination pouch.
•
If the jammed pouch cannot be removed, turn off the laminator immediately
and contact your supplier for assistance.
EMERGENCY STOP
This laminator is equipped with a patented overloading protection
system. In the case of an emergency, hold both sides of the pouch
firmly to stall the feeding of the pouch. The laminator will reverse
itself automatically to eject the pouch.
Please pay attention to the following when operating the laminator.
•
If you cut the lamination pouch before lamination, you must use a carrier. This will prevent adhesive being deposited on
the rollers.
•
Do not use 2 lamination pouches as shown below. It will jam the laminator.
•
The lamination pouch comes in two sheets with one edge sealed. Do not attempt to laminate a single side of the
lamination pouch. The pouch will stick to the laminator roller.
• Always insert the sealed end fi rst.
Anti-Jam Function
Essential Information!
Roller Reverse
button
9
