61
Preparing the Telephone
63
Drill two holes 110 mm apart and vertical to each other and tighten the screws leaving ap-
prox. 5 mm projecting from the wall. Attach the base unit by hooking it in the two screws
protruding from the wall and pushing it down a bit. Turn the handset hook (
no. 1 on Base
Station diagram) by 180° in order to hook up the handset.
Inserting the batteries
Insert the batteries in the open bat-
tery compartment. Only use batte-
ries of the type AAA NiMH 1.2 V.
Pay attention to the correct polarity.
Close the battery compartment
cover.
Charging the batteries
Before the handset is used for the first time, insert it in the base station / charging
station for
at least
14 hours.
When the handset is inserted in the base/charging station properly, you will hear an acoustic
confirmation signal and the charge control lamp lights up. The handset warms up during the
charging process. This is normal and does not represent a risk. Do not charge the handset
with charging units from other manufacturers.
The current
battery charge status
is indicated in the display:
Full
Half empty
Low
Empty
Setting the display language
Select a language (cf. "Menu Structure"):
> PERS. EINST > SPRACHE >... (
> PERSONAL TSE > LANGUAGE >...)
Setting the time and date on the handset
The time and date are set via the menu. Refer to Page 72 for the sequence of menu option
selections.
Auto answer / Auto hang−up
With this feature enabled the telephone will automatically take a call when the handset is re-
moved from the base station and automatically hang up when it is put back on the base sta-
tion. Use the menu to activate or deactivate these functions. Refer to Page 74 for the se-
quence of menu option selections.
Private branch exchanges
The information on Page 75 explains how to install your telephone in a private branch ex-
change.
Low−radiation operation (ECO mode)
The level of radiation is considerably lower than that of standard DECT
cordless telephones when in Standby mode (when the handset is on the
base station). In talk mode, radiation is reduced (depending on the
distance between the handset and base station).
Default setting = ECO MODE
→
OFF
The telephone can be set up so that the radiation frequency is reduced;
Page 74.
