41
Operating the Camera
70
Deregistering the camera from the monitor (deregistration process)
1. Switch the monitor on.
2. Press the
Menu/OK button
on the monitor to open the menu.
3. Use the
Scroll right button
or
Scroll left button
to select the
Setting
menu option.
4. Use the
Scroll up button
or
Scroll down button
to select the
Register
menu option.
5. Press the
Menu/OK button
to confirm your selection.
6. Use the
Scroll up button
or
Scroll down button
to select the channel on which the camera to be
deregistered is set.
7. Press the
Menu/OK button
to confirm your selection.
Information appears in the display on how to proceed:
8. Press the
Menu/OK button
to continue with the deregistration process. Or:
Press the
On/Off / Back button
to cancel the deregistration process.
If a camera is connected to the monitor, a "Y" appears behind the associated camera name in
the
Register
menu option. If a camera is not connected to the monitor, an "N" appears.
9. Exit from the menu by pressing the
On/Off / Back button
, several times if necessary.
If the deregistration process is unsuccessful, check the battery charge status of the monitor and
camera. Charge both units, if necessary.
5
Operating the Camera
Check the camera and monitor units are working properly each time before the equipment is put
into operation.
Switching on the camera
1. Press and hold the
On/Off button
on the camera.
The LED lights up/flashes according to the configuration (refer to Page 62).
2. Adjust the camera alignment again, if necessary.
Switching the camera off
Press and hold the
On/Off button
on the camera until the LED goes out.
Night vision function
The camera is equipped with 8 infrared LEDs. This enables the transmission of pictures from areas which
are not illuminated.
You can use the menu to define whether the night vision function should be permanently switched on or
off or whether the unit should switch the night vision function on automatically when the sensor detects
poor light conditions. Refer to "Menu Structure" (
Infrared
), Page 66.
When the night vision function is activated, the display on the monitor turns to black and white.
Restarting the camera
If the camera no longer behaves as described, restart the camera:
Press the Reset button using a thin, firm object, e.g. a straightened paper clip, to restart the camera.
Содержание BCF 850
Страница 2: ...2 2 Bedienungsanleitung 3 Mode d emploi 22 Istruzioni per l uso 41 Operating Instructions 60...
Страница 79: ......
