40
Putting the Units into Operation
69
When switched on, the icon bar on the monitor screen indicates the battery charge status of the
camera (blue) and monitor (green).
The colors run through the segments in the battery icons in the display during charging. When the battery
is fully charged, the respective battery icon is filled fully.
When charging the battery for the first time, it should be charged for at least 4 hours without inter
ruption. This lengthens the service life of the battery!
Stand with clip
Take hold of the stand on the rear side of the monitor at the bottom and pull it away from the unit a
little to position the monitor.
You can use the clip on the stand to attach the monitor to other objects.
Defining the language
The language is defined using the menu, refer to "Menu Structure" (
Language
), Page 65. There are 4
languages available for selection.
Registering the camera on the monitor (registration process)
The monitor and camera are already registered with each other at the factory.
However, up to 4 cameras can be registered on the monitor. Other cameras can be registered on the
monitor as follows:
1. Switch the monitor on.
2. Switch the (new) camera on.
3. Press the
Menu/OK button
on the monitor to open the menu.
4. Use the
Scroll right button
or
Scroll left button
to select the
Setting
menu option.
5. Use the
Scroll up button
or
Scroll down button
to select the
Register
menu option.
6. Press the
Menu/OK button
to confirm your selection.
7. Use the
Scroll up button
or
Scroll down button
to select the channel to which the new camera should
be set.
8. Press the
Menu/OK button
to confirm your selection.
Information appears in the display on how to proceed:
9. Press the
Menu/OK button
to continue with the registration process. Or:
Press the
On/Off / Back button
to cancel the registration process.
10. Press and hold the
Registration button
on the camera until a message indicating successful
registration appears in the display.
If a camera is connected to the monitor, a "Y" appears behind the associated camera name in
the
Register
menu option. If a camera is not connected to the monitor, an "N" appears.
11. Exit from the menu by pressing the
On/Off / Back button
, several times if necessary.
If the registration process is unsuccessful, check the battery charge status. Charge the battery,
if necessary.
Содержание BCF 850
Страница 2: ...2 2 Bedienungsanleitung 3 Mode d emploi 22 Istruzioni per l uso 41 Operating Instructions 60...
Страница 79: ......
