9
Wireless Port
Link button
and
Link LED
. The Link button is used to link a transmitter to one or multiple receivers. The Link
LED shows if the device is linked.
Signal strength indicator
. In Receiver mode, four green LEDs display the signal strength. In Transmitter mode,
they indicate that the transmitter is active by flashing alternately.
Locking the Device
Lock button
and
Lock LED
. The Lock LED lights up in red when the
Lock function
is activated. In this case, the
Mode and the Link buttons on the left of the Lock button are disabled. This may prevent an unintended
manipulation of the operating mode or of the link status. The Lock button is used to enable/disable the Lock
function. It is only accessible with the use of a tool like a paper clip.
Establishing a Wireless Link
To transmit DMX data wirelessly, a transmitter and one or more receivers are used. The receiver has to be linked to
the transmitter(s). This is achieved as shown below.
Transmitter mode
Receiver mode
Receiver mode
1)
Press the Mode button of the device that is intended
to be used as the transmitter repeatedly until the Tx
LED is turned on in order to activate the Transmitter
mode.
2)
On each device that is intended to be used as a
receiver: Put the device into receiver mode by
pressing the mode button multiple times until the Rx
LED lights up.
Transmitter mode
3sec
Receiver mode
Receiver mode
3sec
3sec
3)
On transmitter: Press and hold the Link button for 3
seconds to unlink all devices previousely linked to
that transmitter.
4)
On each receiver: Press and hold the link button for
3 seconds to unlink the device from any transmitter.
