4
Operating instructions
GB
Continuous operation
Swissflex
®
slat bases:
uni _75RF, _85RF, _95RF
1.
Connect the control system and the handheld
transmitter to the mains. (Wait at least 10 sec.
before initial setup).
2.
Briefly press the function button of the control
system twice (figure 1). The function button and
the under-floor lighting light up, and the system
is now in learning mode for about 10 seconds.
3.
Press buttons (7) + (8) (figure 2) of the hand-
held transmitter at the same time and hold them
down. The function LED (6) begins to flash. Hold
the button down until the blue LED is permanent-
ly illuminated (activation time about 10 sec.).
4.
If the programming of the handheld transmit-
ter fails or the handheld transmitter is turned off,
you can interrupt the communication between the
handheld transmitter and the control system as
follows:
Press the function button of the control system
four times in quick succession (figure 1).
• The function button on the control system
lights up, now press the function button on the
control system once.
• The function button on the control system goes
off, and the handheld transmitter is deactiva-
ted.
5.
Continuous on/off with button (5) (figure 2).
Figure 1:
Function button with
LED on the control system
Figure 2
5
7
6
8
