Swisscom Top A47 ISDN, Руководство по эксплуатации

Страница: 63 / 110

59
203220671en_ba_a0
Additional settings
Set date and time
Normally there is no need to set the date and time since these are automatically updated by the
network with every outgoing call. If the time display is flashing following a power cut or on
startup, the first outgoing call you make will update the date and time.
You can also set the date and time manually:
Press the menu button until »Installation« is displayed.
Press the softkey repeatedly under » « until the display shows »Date/Time«.
change
Press the softkey repeatedly under »change« until the date is displayed.
Enter the date in ddmmyy format without separating dots.
Example: 20. January 2001 = 200101.
ok
Press the softkey under »ok« to show the time.
Enter the time in 24-hour hhmm format without separating dots.
Example: 4.08 p.m. = 1608.
ok
Press the softkey repeatedly under »ok« to show »Date/Time« again.
To exit the menu, press the EXIT button.
➭
The time will be updated again by the network with the next outgoing call.
Interception circuit (Malicious Call ID)
This service is available on request. It allows calls to be monitored during the connection and the
data retained up to 20 seconds after the handset is replaced. The exchange registers the calling
number, date and time, even if the caller has suppressed his number (CLIR).
If you subscribe to this service you can activate it at the touch of a speed dial button, see
»Programming speed dial buttons«.
The display shows that a caller has suppressed his number.
Lift the handset.
Press the softkey repeatedly under » « until »MCID« is shown.
MCID
Press the softkey under »MCID«. MCID is activated.