Swisscom Aton CL700, Руководство пользователя

Страница: 33 / 38

29
Appendix
Aton CL700 IP / Swisscom EN / A31008-M1713-F161-1-2X43 / appendix.fm / 27.9.06
Ve
rs
ion 4,
16
.09.
2005
Appendix
Care
¤
Wipe down the base station and hand-
set with a damp cloth (no solvents) or
an antistatic cloth.
Never use a dry cloth. This can cause a
build up of static.
Contact with liquid
If the handset has come into contact with
liquid:
¤
Turn the handset off and remove the
batteries immediately.
¤
Allow the liquid to drain from the hand-
set.
¤
Pat all parts dry, then with the battery
compartment open and the keypad fac-
ing down, place the handset in a dry,
warm place for at least 72 hours
( not in a microwave, oven etc.).
¤
Do not turn on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Faults and self-help with
troubleshooting
Not every problem signifies a fault in your
telephone. In some cases, problems can
be resolved by briefly interrupting the
power supply to the base station (unplug
the power supply unit and then plug it in
again) or removing the battery cells from
the handset and reinserting them. The fol-
lowing information is designed to help
you with specific problems.
Important: Some problems or faults can
only be resolved if you take the complete
device (base station, handset and connec-
tion cable) to the place of purchase.
* Refer to the detailed user guide for your
Aton CL700 IP at www.siemens.com/gigaset.
!
The display is blank.
1. The handset is not turned on.
¥
Press and hold the end call key
a
.
2. The batteries are flat.
¥
Charge or replace the batteries (page 6).
"Base station x" flashes on the display.
1. The handset is outside the range of the base
station.
¥
Move the handset closer to the base sta-
tion.
2. The handset has been de-registered.
¥
Register the handset*.
3. The base station is not turned on.
¥
Check the base station's mains adapter
(page 8).
Base Search is flashing in the display.
The handset is set to Best Base and no base sta-
tion is turned on or within range.
¥
Move the handset closer to the base station.
¥
Check the base station's mains adapter
(page 8).
Handset does not ring.
1. The ringtone is turned off.
¥
Activate the ringtone (page 27).
2. Call diversion set to All Calls .
¥
Turn off call diversion*.
You cannot hear a ringtone/dialling tone.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, ensure that it
has the correct pin connections (page 9).
The other party cannot hear you.
You have pressed the
u
(INT) key. The hand-
set is "muted".
¥
Turn on the microphone again*.