17
Appendix
Gigaset S45 / SWZ PTT-en / Internet / start_guide_time.fm / 02.06.2006
¤
Save changes (page 21).
You will see the
¼
icon.
A wake-up call with the selected ringer
melody is signalled on the handset. The
wake up call sounds for 60 seconds. The
display shows an
Alarm Clock
. If no key is
pressed the wake-up call is repeated twice
at five minute intervals and then switched
off.
During a call, the wake-up call is signalled
by a short tone.
Deactivating the wake-up call/
repeating after a pause (slumber
mode)
Requirement
: A wake-up call is sounding.
§OFF§
Press the display key. The
wake-up call is deactivated.
or
§Snooze§
Press the display key or any
key. The wake-up call is deacti-
vated and then repeated after
5 minutes. After the second
repetition the wake-up call is
deactivated completely.
Restoring the handset default
settings
You can reset any individual settings and
changes that you have made. This will not
affect entries in the directory or calls list,
nor the handset's registration to the base
station.
v
¢
Ð
¢
Handset
¢
Reset Handset
§Yes§
Press the display key.
Cancel the restoring process by pressing
a
or the display key
§No§
.
a
Press
and
hold
(idle status).
Appendix
Care
¤
Wipe the charging cradle and the hand-
set with a
damp
cloth (do not use sol-
vent) or an antistatic cloth.
Never
use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Switch the handset off and remove
the batteries immediately
.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place f
or at least 72 hours
(
not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Faults and Self-help with
Troubleshooting
Not every fault is due to a defective
phone. In certain circumstances, it can
come from a brief interruption in the
power supply to the base station (unplug/
plug in power supply) or if the batteries of
the handset are removed and inserted
again. The following instructions should
be of help for specific faults.
I
mportant:
problems or faults can only be
remedied if you bring the complete unit
(base station, handset, as well as connect-
ing cable) to the place of purchase.
!
