Swisscom Aton CL118 DUO, Руководство пользователя

Страница: 30 / 37

28
Aton CL118 - A540 / en / A31008-M2601-F151-1-2X19 / appendix.fm / 09.12.2014
A-K
lasse
_La
you
t_
Ne
u, V
e
rsi
on
4
, 28.05
.2
014
Manufacturer's advice
The caller's number is not displayed.
• Calling Line Identification (CLI) is not approved for the caller:
¤
Caller should ask the network provider to
enable Calling Line Identification (CLI).
• Calling Line Identification Presentation (CLIP) is not supported or approved by the network provider:
¤
Caller display (CLIP) must be enabled by the network provider.
• The telephone is connected via a PABX or a router with an integrated PABX (gateway) that does not transmit
all information:
¤
Reset the system: Briefly pull out the power plug. Reinsert the plug and wait until the device restarts.
¤
Check the settings on the PABX and activate telephone number display, if necessary. To do this, search
for terms such as CLIP, calling line identification, telephone number identification, caller ID, etc. in the user
guide of the system or ask the system manufacturer.
Error tone with keypad entries.
• Action has failed/invalid input:
¤
Repeat the procedure
. . .
Read the display and refer to the user guide if
necessary.
The messages on the network mailbox cannot be listened.
• The PABX is set to pulse dialling:
¤
Set the PABX to tone dialling (
¢
page 22).
Appendix
Care
Wipe the device with a damp cloth or an antistatic cloth. Do not use solvents or microfibre cloths.
Never use a dry cloth; this can cause static.
In rare cases, contact with chemical substances can cause changes to the device’s exterior. Due to the wide
variety of chemical products available on the market, it was not possible to test all substances.
Impairments in high-gloss finishes can be carefully removed using display polishes for mobile phones.
Contact with liquid
If the device comes into contact with liquid:
1. Disconnect the power supply.
2. Remove the batteries and leave the battery compartment open.
3. Allow the liquid to drain from the device.
4. Pat all parts dry.
5. Place the device in a dry, warm place for at least 72 hours ( not in a microwave, oven etc.) with the battery
compartment open and the keypad facing down (if applicable).
6. Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
!