NOTE:
This timer means the device will keep frying or doing hot pot for the time you
input .After the set time elapsed. The device will come back to standby mode .You can select from 0-3 hours.
When you choose function WATER/STEW/HEAT-UP,then press “TIMER/PRESET” button ,the
display shows “0:30”.
Briefly press the “+” button to set the time increments of 30 minutes. Press the “-” button to set the time in
decrements of one minute. The display will show the desired setting.
NOTE:
This setting means the device will come back to standy mode immediately after you input the time.After the
set time has elapsed, the device will start to work under the functions you selected (WATER/STEW/HEAT-UP).
You can select from 0-24 hours.
You may change the previous timer/preset at any time.The other settings will remain.
TO cancel the timer/preset ,select the display to “0:00”. The cooking plate will keep the function which you have
chosen before.You may aslo turn the appliance off directly with the “ON/OFF” button.
Check voltage and power comsuption
When the device is working, you can press “ELECTRICITY” button to check the voltage and power comsumption.
Press once,display shows: V229 or V230(Normal voltage can be from V220 to V240). Press again, display will
show this time how much power consumpted after you swtich the device on.Eg .P0.04 means 0.04 kwh.
PAN RECOGNITION
The device has a pot recognition function .It gives several warnings to indicate that the cookware Has beend
removed ,The message “E0” appears on the display.For safety reasons ,the appliance will switch to standy mode
after about 60 seconds. The fan may continue running.In this context,please pay attention to the following:
WARNING:
After use, the hot plate is to be switched off by means of its regulation and control devices
(ON/OFF button ) and not just by pan recognition .
WARNING: Harzard of burns !
Because of the heat radiated during cooking, dangerously high temperatures may occur at the cooking zone
after the cooking cycle.
CLEANING
WARNING:
Always remove the main plug before cleaning!
Wait until the device has cooled down completely!
Under no circumstances should you immerse the device in water for cleaning purposes. Otherwise this
might result in an electric shock or fire .
